Page 1 of 1

Connet Lidar sensor for Igor

Posted: Wed Dec 09, 2020 2:27 am
by zhuwei996
Hi here,

I want to connet a Lidar senser for Igor. The communication mode of the Lidar sensor is Ethernet.
There is a USB port for users. I wonder if I can use a usb-to-ethernet converter.
Would the converter influence the communication between actuators and on-board computer?

Thank you

Any help would be greatly appreciated.

Re: Connet Lidar sensor for Igor

Posted: Wed Dec 09, 2020 12:45 pm
by curtis_layton
Hi,

Using a USB to Ethernet adapter will work fine in this situation and it should not have any negative effect on the actuators as it will be on a separate network.

Thank you,

- Curtis

Re: Connet Lidar sensor for Igor

Posted: Wed Dec 09, 2020 6:52 pm
by zhuwei996
curtis_layton wrote:
Wed Dec 09, 2020 12:45 pm
Hi,

Using a USB to Ethernet adapter will work fine in this situation and it should not have any negative effect on the actuators as it will be on a separate network.

Thank you,

- Curtis
Hi,

Thanks for your prompt response. It helps me great!

Wei