Page 1 of 1
Scope on Raspberry Pi
Posted: Tue Dec 31, 2019 3:56 pm
by hebi_newbie
I want to know if the Scope app can be installed on a Raspberry Pi after setting cross compilation for 64bit? I am using the X-series actuators.
Re: Scope on Raspberry Pi
Posted: Tue Dec 31, 2019 4:40 pm
by dave_rollinson
Scope currently does not support Raspberry Pi or other ARM-based platforms.
This is in part because there are no pre-built binaries (jmods) for OpenJFX:
https://gluonhq.com/products/javafx/
Re: Scope on Raspberry Pi
Posted: Tue Dec 31, 2019 4:40 pm
by dave_rollinson
Also, just in case you are not aware I'd also like to point out that Scope is independent from the APIs and can be run on any computer on the same network.
So as long as you are connected, you can run Scope from your development machine even if the robot is controlled from a Raspberry Pi.