Scope on Raspberry Pi
- hebi_newbie
- Posts: 34
- Joined: Wed Oct 02, 2019 4:41 pm
Scope on Raspberry Pi
I want to know if the Scope app can be installed on a Raspberry Pi after setting cross compilation for 64bit? I am using the X-series actuators.
- dave_rollinson
- HEBI Official
- Posts: 41
- Joined: Tue Dec 31, 2019 11:58 am
Re: Scope on Raspberry Pi
Scope currently does not support Raspberry Pi or other ARM-based platforms.
This is in part because there are no pre-built binaries (jmods) for OpenJFX:
https://gluonhq.com/products/javafx/
This is in part because there are no pre-built binaries (jmods) for OpenJFX:
https://gluonhq.com/products/javafx/
- dave_rollinson
- HEBI Official
- Posts: 41
- Joined: Tue Dec 31, 2019 11:58 am
Re: Scope on Raspberry Pi
Also, just in case you are not aware I'd also like to point out that Scope is independent from the APIs and can be run on any computer on the same network.
So as long as you are connected, you can run Scope from your development machine even if the robot is controlled from a Raspberry Pi.
So as long as you are connected, you can run Scope from your development machine even if the robot is controlled from a Raspberry Pi.